This property sets the number of images to be scanned. This property is only enabled when using a custom-built user interface (UserInterface=Suppress).
Property Value
Value | Explanation |
---|---|
0 or less | Scans all images (ADF, digital camera) |
1 or more | Scans the specified number of images |
Default value is -1.
Explanation
The PageCount property sets the number of images to be scanned. This property is enabled when the UserInterface property is Suppress. To scan all of the images in the ADF or digital camera, set this property to 0 or less. To specify the number of images to be scanned, set that number in the PageCount property. When retrieving images from a digital camera using an array, pleaes refer to the Execute method to be the same as the number of elements in the array. When the Mode property is ADFBothSide, even if an odd number is set into the PageCount property, the number of pages scanned will be an even number (so as to scan both sides of the paper).
The PageCount property is disabled when the UserInterface property is NOT
Suppress or when using the document plate to scan. For Panasonic
scanners, when the PixelType
property is GrayAndBW or RGBAndBW, even if
the PageCount property value is 1 or more, the
specified number of images are scanned.
Note: Not all scan devices support this functionality. In some
cases where the scan device does not support this function or does
not correctly support this function, after the number of images
specified by the PageCount property have been scanned, the
scanning procedure is canceled. Depending on the type of equipment,
paper could be left inside the scan device or ADF.